Validating the application running on the PLC
This article is about the workflow phase "integration and system test" for an application .
The application running on the PLC is validated based on the test specification for the application. This validation must be documented by a test report for the application.
The test specification for the application and the test report for the application are not detailed in this safety manual. If you need details, consult the relevant standards or other appropriate documentation.
The integration and system tests are required to provide evidence that the application
fulfills the requirements when executed on the safety PLC and
contains neither undesired functionalities nor undesired properties.
The validation is not done in logi.CAD 3 . However, some features or logi.CAD 3 (such as the Values of Variables view) may be used to support the validation.
See the safety manual for the target platform for instructions and warnings on a validation , e.g. the " logi.µSRTS safety manual", article "Validating the application running on the PLC".
When validating an application, comply with the warnings as specified in this safety manual for the target platform and the following warning 1 and warning 2 :