Viewing or changing the current parameter values

The safety parameter editor provides the possibility to be informed about the current configuration of safety relevant hardware devices and to change the values:

1. Expand the group with the parameter value: Click on the icon which is displayed in front of the group name or click on the name of the group itself. Or navigate to the icon by using the Tab-key and press the Enter-key .

2. Repeat expanding the groups until the parameter value is visible.
   Alternative: Expand all groups at once by clicking Expand all in the control bar. Or navigate to Expand all by using the Tab-key and press the Enter-key.

3. Make sure that the column Value shows the correct value of the parameter.
   When you hover over the field for Value , a tooltip informs you about the parameter data. Details: see "Components of the safety parameter editor".

4. If you want to change this value, proceed as follows:

   1. Click in the field for the column Value. Change the value depending on the parameter: Specify the new value in the field, select the value from the given list or check the checkbox (or uncheck an existing checkbox).
      Result: The field for Value is highlighted with a yellow background color, as long as the change is not confirmed.

   2. Required for an entry field only: Confirm the change by pressing the Enter-key, clicking into the next field or pressing the Tab-key (to go to the next field). Press the ESC-key, if you want to discard your changes (in this case the original value will be restored).
      Result in case of a correct change: The background color of the field reverts back to white.
      Result of an incorrect change (see the illustration under " Hardware parameterization using the safety parameter editor ") : The field is highlighted with a red background color. In addition, a message (an error) in the line below the incorrect parameter informs about the incorrect value. In this case, correct the value correspondingly.
      Result of a change for which the safety parameter editor corrects the value to a correct value (see the following example 1 and example 2): The yellow background color is kept. In this case, a message (a warning) in the line below the changed parameter informs about the change of the safety parameter editor. In order to confirm the change, again press the Enter-key, click into the next field or press the Tab-key (to go to the next field). In order to restore the original value, press the ESC-key.
      

5. If the column Commissionable contains a check box, you can additionally decide whether this parameter can be changed at application runtime. If yes, check this box. If not, do not check it.
   

6. Repeat the steps 4 and 5 for each value you want to change.

Example 1: You are changing the parameter value 6 to the value 07. The field for Value is highlighted with a yellow background color because you need to confirm your change first. If the s afety parameter editor changes the invalid value 07 to the valid value 7 (this change is done after you have confirmed your change), the yellow background color of the field is kept and a warning informs you about the change to the value 7. Now e.g. press the Enter-key in order to confirm the value 7 that has been entered by the safety parameter editor instead of your value 07. Or press the ESC-key in order to restore the original value 6.

Example 2: You are changing a floating point value to the value 3.14151617181920. The field for Value is highlighted with a yellow background color because you need to confirm your change first. As the value is too long, the safety parameter editor truncates the value (this also changes your value that you confirmed). Here, the yellow background color of the field is kept as well and a warning informs you about the change. Now e.g. press the Enter-key in order to confirm the value that has been entered by the safety parameter editor instead of your value. Or press the ESC-key in order to restore the original floating point value.