Errors and warnings in the enum-editor
This section is intended for the errors/warnings that might occur when creating the content within the enum-editor.
However, it is possible that errors/warnings occur for the enum-editor as when
entering the ST-code. See "Errors and warnings in ST" for this message and its appropriate solution.
creating the function block diagram. See "Errors and warnings in FBD" for this message and its appropriate solution.
validating the application. See "Errors and warnings when validating the application" for this message and its appropriate solution.
Invalid name or
This name is already used.
Solution: Enter a unique →IEC-identifier as name that has not been used for the elements of the current enum yet.
Invalid expression
Solution: Change the expression to an expression according to ST that is valid for the →data type.
Errors occurred while refactoring the enum "name".
Solution: Try to rename the element of the current enum again. If the message is displayed again:
Contact the support team of logi.cals. Include your contact information, information on what you were doing in logi.CAD 3 and all messages listed in
the Error Log view, Problems view and/or PLC Logging view.